Planar PL2011M Manuel d'utilisateur télécharger pdf (Page 8)

Optional Mounting Alternatives

Warning:

The monitor stand base may forcefully extend and cause injury.

Raise the monitor to its "Full Up" position before removing the monitor

stand.

Detaching LCD Monitor from Its Stand

Unscrew screws n the swivel base support column and pull downo the

second.

Figure 1-3

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-3.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches

threaded nuts, as well as four 5 mm access holes in the plastic covering

as illustrated in Figure 1-4. These specifications meet the VESA Flat

Panel Monitor Physical Mounting Interface Standard (paragraphs

2.1 and 2.1.3, version 1, dated 13 November 1997).

Note :Please using Ø 4mm x 8mm (L) screw for this application.

Figure 1-4

Power Management System

This LCD Monitor complies with the VESA DPMS (version 1.0) Power Management guidelines. The

VESA DPMS provides four power saving modes through detecting a horizontal or vertical sync. signal.

When the LCD Monitor is in power saving mode, the monitor screen will be blank and the power LED

indicator will light yellow.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Planar PL2011M Manuel d'utilisateur Page 8