Planar PT1710MX Manuel d'utilisateur

PT1710MX Touchscreen LCD Monitors USER’S GUIDE www.planar.com

6 Installation Product Overview  Front View  Back View

7 ¡ Connector Ports “A” ¡ Connector Ports “B” USB Audio input VGA input RS-232input DC Power-in

8  Kensington Security Slot The monitor can be secured to your desk or any other fixed object with Kensington lock security products. The Kensin

9 VESA Mount your monitor This monitor conforms to the VESA Flat Panel Mounting Physical Mounting Interface Standard which defines a physical mountin

10 Start Your Installation ¡ Remove the Back Cover Please follow these instructions to remove the cover on the back panel of the LCD so that

11  Connecting the Display (Figure 11.1) To setup this display, please refer to the following figure and procedures. 1. Be sure all equipment is t

12 Figure 11.1

13User ControlsFront Panel Controls No / Icon Control Function X MENU Menu button Display the OSD menus YSELECT/AUTO Select/Auto Select

14 How to Use the OSD Menus 1. Press the "MENU" button to pop up the “on-screen menu” and to select among the four Main Menus. 2. Cho

15 On-Screen Display Menus Main OSD Menu: MAIN MENU SUB MENU Function Description Auto-Adjustment No/Yes Choose this function to obtain an optimum

16 Appendix Troubleshooting If you are experiencing trouble with the LCD display, refer to the following. If the problem persists, please contact you

17 Warning Signal If you see warning messages on your LCD screen, this means that the LCD display cannot receive a clean signal from the computer gra

18 Product Dimensions

19 Compatibility Modes Mode Resolution V. Frequency (Hz) H. Frequency (kHz) IBM VGA 640 x 350 70 31.5 IBM VGA 720 x 400 70 31.5 IBM VGA 640 x 480

20 Touch Screen Driver Installation The touch driver is located on the enclosed CD-ROM for these operating systems: Windows Me/2000/XP series. Drive

21 Figure 1 6. For RS-232 Serial connection select “Gunze, AHL, Serial” and the COM port to connect to the touch panel. See Figure 2.

22 7. The operation area of the touchscreen can be assigned by the “Logical desktop segment” function. Select your preference. Most common choice wi

23 9. After clicking “Apply” connect your USB or RS-232 cable from your display to your PC. 10. Steps 11-14 apply to USB connection only. For Serial

24 17. Make contact with the “X” markings on the screen. Be sure your stylus or finger is centered on each “X” point See Figure 6. Figu

25 Planar Systems, Inc. Customer Service 24x7 Online Technical Support: http://www.planar.com/support 1195 NW Compton Drive Beaverton,

Important Recycle Instruction: LCD Lamp(s) inside this product contain mercury. This product may contain other electronic waste that can

1 Table of Contents Usage Notice Precautions ...2 Introduc

2 Usage Notice Warning- To prevent the risk of fire or shock hazards, do not expose this product to rain or moisture. Warning- Please do not ope

3 IntroductionAbout Planar’s PT1710MX The PT1710MX is a 17” flat panel screen with an active matrix, thin-film transistor (TFT) liquid crystal disp

4 Touch Screen for PT1710MX  Gunze analog 5-wire resistive touch screen for finger and stylus input  Surface: Anti-glare treatment  Interface:

5 Package Overview LCD Display Power Adapter Power Cord VGA Signal Cable Audio-in Cable USB Cable RS-232 Cable Landing Strip Touchscreen